Faro Water Is Very Hard — Here's What It Costs You Each Year

At 16.8 GPG (287 ppm), Faro water is +158% harder than the Canadian national average — and the damage shows up everywhere:

• Water heaters fail early. The Battelle Memorial Institute study found very-hard-water heaters failed in under 2 years, while softened-water units lasted the full 10-year test period. That's appliance life being burned through at 5× speed.
• Energy waste. Scale insulates the heating element, forcing the unit to work up to 13% harder — a direct, recurring cost on every bill.
• Constant descaling. Showerheads clog, faucet aerators crust over, and glassware never looks clean without a rinse aid.
• Up to 75% more detergent. Per the Water Quality Association, hard water sharply reduces soap effectiveness, and mineral residue roughs up fabric fibers, wearing clothes faster.

This isn't cosmetic. It's equipment and energy cost, quantified — at 16.8 GPG the running total is roughly $2,066 per year for an average 3–4 person home (see the calculator above — adjust the household size to see your number).

Yes — this is close to a non-negotiable. At 16.8 GPG, Faro homeowners don't really debate whether to treat; they debate which system. The annual hard-water cost here is around $2,066, so a quality softener (~$1,000 installed) typically recovers its cost in well under a year.

Salt-free conditioners won't cut it at 16.8 GPG — they reduce scale but can't remove the minerals causing the soap, skin, and appliance problems. You need ion exchange. Size the unit to your household: a 48,000-grain softener handles a typical 3–4 person home at this hardness.

Sizing a softener is a two-number equation: your household's daily water use × your hardness. The rule of thumb is grains per day = (people) × (75 gallons) × (GPG).

• At 16.8 GPG, a family of four uses roughly 5,040 grains of hardness per day.
• A 48,000-grain softener regenerates roughly every 5–8 days — within the 3–7 day window that keeps salt and water use efficient.
• Round up, not down: an undersized unit regenerates too often and wastes salt. Metered (on-demand) regeneration saves the most salt and water.

For Faro at 16.8 GPG, a 48,000-grain metered softener is the safe default for a 3–4 person home. A larger household, or one with unusually high water use, should size up to 64,000 grains.

At 16.8 GPG (287 ppm), Faro residents notice severe hard-water effects. The USGS classifies water above 7 GPG as hard and notes it causes measurable physical damage to plumbing and appliances.

• White or grey crust on faucet aerators, showerheads, and around drains — calcium carbonate depositing as water evaporates.
• Spotty glassware even after a full dishwasher cycle — mineral film left behind when water dries.
• Falling water-heater efficiency — scale insulates the heating element, forcing the unit to work harder and pushing up the energy bill.
• Flat, stiff hair — calcium bonds to hair proteins and prevents shampoo from rinsing clean.
• Dry, itchy skin — dissolved minerals disrupt the skin's moisture barrier.
• Weak soap lather — hardness ions react with soap to form insoluble scum instead of suds.
• Shorter appliance life — washing machines, dishwashers, and coffee makers accumulate internal scale.

The Battelle Memorial Institute study commissioned by the Water Quality Research Foundation found untreated very-hard-water heaters failed in under 2 years, versus a full 10 years on softened water. At Faro's 16.8 GPG, that equipment degradation compounds faster than most homeowners expect.

This page reports Faro's system-wide average (16.8 GPG), but your tap can vary slightly by neighborhood, pipe age, and in-home filtration. For a step-by-step, see how to test your water hardness at home — it walks through test strips, the free soap-shake check, TDS meters, titration kits, and certified lab tests.

• Test strips (~$10) give a GPG reading in about 30 seconds and are accurate enough to decide whether to invest in treatment.
• TDS meter (~$15) measures total dissolved solids, a rough hardness proxy — but it doesn't separate hardness from other minerals.
• Lab test — most water treatment companies in Faro offer free in-home tests (expect a sales pitch); for an independent result, the EPA maintains a list of certified labs.

Note: the EPA doesn't regulate hardness (it's a nuisance, not a health hazard), but the EWG Tap Water Database tracks contaminants above health guidelines for Faro's utility — see the table below.

Get water hardness test strips (~$10) →